The common failure of snake spring coupling in practice

At present, it can be observed that the mechanical manufacturers using the snake spring coupling are increasing, but the coupling transmission parts in the process of use will appear some common failures. But now there are some customers on the coupling transmission parts of the common failure is not very understand, so you do not have to worry, the following can follow the manufacturer to understand it.

Snake spring coupling in practice, often possible accidents are:
1. Coupling axis collision skew, coupling not into: in order to prevent this kind of accident, in addition to the alignment of the axis, coupling hole and shaft position, the position of the block to do the correct, but also pay attention to the impact point position to choose, the first one, two to light, to be in a distance (about 1/3), before the force to strike.
2. Other accidents may include: block pulley due to the position is not fastened and backward, hoist chain sliding down, fuel shortage, fire alarm, etc., should be paid attention to in advance, carefully check in the tool preparation and operation training stage.
3. When precision components such as bearings and mechanical seals have been installed on the spindle in advance, it is forbidden to strike or impact the coupling forcefully to prevent damage or damage to precision components.

The above is the manufacturer to explain to you about the snake spring coupling in the actual use of the fault often occur, our manufacturer hopes that you need to pay attention to the occurrence of these faults in the process of use, so as to improve the service life of the coupling. If you still do not understand the place can be timely to consult our manufacturers.